Rear Seat Back Cushion Stowage Latch Actuator Replacement (With 40 Percent Seat)

Fig 1: Identifying Rear Seat Back Cushion Stowage Latch Actuator (With 40 Percent Seat)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the rear seat . Refer to Rear Seat Replacement (With 40 Percent Seat) , Rear Seat Replacement (With 60 Percent Seat) . Remove the rear seat back cushion cover and pad. Refer to Rear Seat Back Cushion Cover and Pad Replacement (with 60 Percent Seat) , Rear Seat Back Cushion Cover and Pad Replacement (with 40 Percent Seat without Armrest) , Rear Seat Back Cushion Cover and Pad Replacement (with 40 Percent Seat with Armrest) .
1	Rear Seat Screw CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
2	Rear Seat Back Cushion Stowage Latch Actuator Procedure Disconnect the cable and note the cable routing for installation. The stowage latch actuator housing must be located over the latch release handle cable. The white area of the cable must fit into the seat back frame hooks.

Callout

Component Name

Preliminary Procedures

Rear Seat Screw

CAUTION:

Tighten
2 N.m (18 lb in)

Rear Seat Back Cushion Stowage Latch Actuator

Procedure

Disconnect the cable and note the cable routing for installation.
The stowage latch actuator housing must be located over the latch release handle cable.
The white area of the cable must fit into the seat back frame hooks.