Rear Seat Inner Recliner Cable Replacement (Short Cable with 60 Percent Seat)

Fig 1: Identifying Rear Seat Inner Recliner Cable (Short Cable With 60 Percent Seat)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the rear seat . Refer to Rear Seat Replacement (With 40 Percent Seat) , Rear Seat Replacement (With 60 Percent Seat) . Remove the rear seat outboard outer recliner cover. Refer to Rear Seat Recliner Outer Finish Cover Replacement - Inboard (with 40 Percent Seat) . Remove the rear back cushion filler panel. Refer to Rear Seat Back Filler Panel Replacement (with 40 Percent Seat) .
1	Plastic Retainer Clip TIP: Note the location of the retainer clip when removing the cable and always make sure the cable is attached to the clip in the same location.
2	Rear Seat Back Latch Release Cable Procedure Note the routing of the cable for installation purposes. Disconnect the cable from the recliner.

Callout

Component Name

Preliminary Procedures

Remove the rear seat . Refer to Rear Seat Replacement (With 40 Percent Seat) , Rear Seat Replacement (With 60 Percent Seat) .
Remove the rear seat outboard outer recliner cover. Refer to Rear Seat Recliner Outer Finish Cover Replacement - Inboard (with 40 Percent Seat) .
Remove the rear back cushion filler panel. Refer to Rear Seat Back Filler Panel Replacement (with 40 Percent Seat) .

Plastic Retainer Clip
TIP: Note the location of the retainer clip when removing the cable and always make sure the cable is attached to the clip in the same location.

Rear Seat Back Latch Release Cable

Procedure

Note the routing of the cable for installation purposes.
Disconnect the cable from the recliner.