Rear Seat Inner Recliner Cable Replacement (Short Cable with 40 Percent Seat)

Preliminary Procedures

1. Remove the rear seat . Refer to Rear Seat Replacement (With 40 Percent Seat) , Rear Seat Replacement (With 60 Percent Seat) .
2. Remove the rear seat outboard outer recliner cover. Refer to Rear Seat Recliner Outer Finish Cover Replacement - Inboard (with 40 Percent Seat) .
3. Remove the rear back cushion filler panel. Refer to Rear Seat Back Filler Panel Replacement (with 40 Percent Seat) .

Procedure

1. Note the routing of the cable for installation purposes.
2. Disconnect the cable from the recliner.
3. Note the location of the retainer clip when removing the cable and always make sure the cable is attached to the clip in the same location.