Hood Hinge Replacement

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Hod Hinges & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. Preliminary Procedures Remove the hood. Refer to Hood Replacement . Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement . Remove the hood open assist spring. Refer to Hood Open Assist Spring Replacement .
1	Hood Upper Hinge Bolt NOTE: Refer to Fastener Notice . Tighten: 25 N.m (18 lb ft)
2	Hood Upper Hinge
3	Hood Lower Hinge Welds CAUTION: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury. Procedure: Locate and drill out all factory welds. Note weld are only for factory processing purposes. The replacement hinge does not need to be welded, just bolted on.
4	Hood Lower Hinge Bolt (Qty: 3) Tighten: 25 N.m (18 lb ft)
5	Hood Lower Hinge