Hood Replacement

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Hood & Bolts

Courtesy of GENERAL MOTORS CORP.

Hood Replacement

Callout	Component Name
CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. Preliminary Procedure Disconnect the hood strut. Refer to Hood Strut Replacement . Remove the air inlet panel end panels. Refer to Air Inlet Grille Panel Replacement .
1	Hood Link Upper Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 25 N.m (18 lb ft)
2	Hood Hinge Pivot Bolt (Qty: 2) Tighten: 25 N.m (18 lb ft)
3	Hood Tip: Disconnect any electrical connectors before removing. Transfer any parts as needed.