Front Side Door Window Regulator Replacement (Power)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Side Door Window Regulator & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Position the door window as needed for service. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement (YE9) or Front Side Door Trim Panel Replacement (SLT) . Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
1	Front Side Door Window Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Procedure Tape the window to the door frame to prevent it from moving. Loosen the 2 bolts that attach the window to the window regulator. Tighten: 9 N.m (80 lb in)
2	Front Side Door Window Regulator Bolt (Qty: 3) Tighten: 9 N.m (80 lb in)
3	Front Side Door Window Regulator Nut (Qty: 2) Tighten: 9 N.m (80 lb in)
4	Front Side Door Window Regulator Procedure Disconnect the electrical connector. Transfer the power window motor to the new regulator. Refer to Front Side Door Window Regulator Motor Replacement .