Front Side Door Trim Panel Replacement (SLT)
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP. Front Side Door Trim Panel Replacement (SLT)
| Callout |
Component Name |
|
Preliminary Procedure
- Remove the door upper trim panel. Refer to Upper Extension Trim Panel Replacement .
- Remove the door window control switch. Refer to Door Lock and Side Window Switch Replacement - Driver Side
and Door Lock and Side Window Switch Replacement - Passenger Side
.
|
| 1 |
Front Side Door Locking Rod Knob Assembly
Tip:
- Lower the window.
- Ensure the locking rod is in the unlocked position.
- Use a flat-bladed tool to disengage the detent tab and then remove the knob by pulling upward.
- When re-installing, push the knob down until the detent tab touches the locking rod opening cover.
- Push the detent tab in to lock the knob to the locking rod.
|
| 2 |
Front Side Door Trim Panel Cover |
| 3 |
Front Side Door Trim Panel Cover Retainer (Qty: 3) |
| 4 |
Front Side Door Inside Handle Bezel Cover |
| 5 |
Front Side Door Trim Panel Bolt (Qty: 3)
Tighten:
2 N.m (18 lb in)
|
| 6 |
Front Side Door Trim Panel Assembly
Tip:
- Disconnect the electrical connectors.
- There are 2 hooks located on the lower portion of the door trim panel that are being used for manufacturing installation ONLY.
- If these hooks are damaged during either removal or installation of the door trim panel, replacement of the panel is not required.
- When installing the trim panel start at the lock knob, pushing down and outward moving toward the upper front.
|
| 7 |
Front Side Door Cable Retainer
Tip:
Pull upward to disengage. |
| 8 |
Front Side Door Trim Panel Retainer (Qty: 12) |