Instrument Panel Carrier Support Replacement (without RPO SLT)
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP. Instrument Panel Carrier Support Replacement (without RPO SLT)
| Callout |
Component Name |
|
Preliminary Procedures
- Remove the instrument panel lower trim panel assembly. Refer to Instrument Panel Upper Trim Panel Replacement (without RPO SLT) or Instrument Panel Upper Trim Panel Replacement (with RPO SLT) .
- Remove the brake pedal assembly. Refer to Brake Pedal Assembly Replacement
.
- Remove the body control module bracket. Refer to Body Control Module Bracket Replacement
.
|
| 1 |
Instrument Panel Carrier Support Bolt (Qty: 5)
Tighten:
22 N.m (16 lb ft)
|
| 2 |
Instrument Panel Carrier Support Assembly
Tip:
- Note location and routing of the instrument panel wiring harness prior to removal of the instrument panel carrier support assembly to ensure proper reinstallation.
- Disconnect the wiring harness from the instrument panel carrier support assembly.
- With the aid of an assistant, remove the instrument panel carrier support assembly from the vehicle.
- If replacing the instrument panel carrier support assembly, transfer all necessary components.
|