LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1588 (Parking Brake System) >> Repair Instructions >> Parking Brake Lever Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Park Brake Cable Grommet
    GM376010Courtesy of GENERAL MOTORS CORP.
    NOTE: Ensure the grommet for the front park brake cable is properly seated in the front floor panel.
  1. Insert the front brake cable through the hole in the front floor panel and seat the pass-through grommet.
  2. Position the floor carpet to the floor pan.
    3. Fig 2: View Of Park Brake Lever Mounting Nuts
    GM1688777Courtesy of GENERAL MOTORS CORP.
  3. Position the park brake pedal assembly on the side panel.
    4. CAUTION: Refer to Fastener Caution .
  4. Install and finger tighten the mounting nuts. Tighten the nuts to 25 N.m (18 lb ft).
  5. Connect the park brake warning lamp connection.
    6. Fig 3: View Of Park Brake Release Lever Handle & Bolt
    GM376009Courtesy of GENERAL MOTORS CORP.
  6. Install the park brake release handle to the instrument panel.
  7. Install the park brake release handle bolt and tighten to 9 N.m (80 lb in).
  8. Install the hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement .
  9. Install the left side instrument panel electrical center/junction block. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Left Side .
  10. Raise the vehicle.
    11. Fig 4: View Of Park Brake Cable - Front/Intermediate
    GM363830Courtesy of GENERAL MOTORS CORP.
  11. Install the front park brake cable to the frame and press the retainer into place.
  12. Connect the front park brake cable to the front to intermediate park brake cable connector.
  13. Lower the vehicle.
  14. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
  15. Adjust the park brake. Refer to Parking Brake Adjustment (1500 Drum Brake)  or Parking Brake Adjustment (1500 Disc Brake)  or Parking Brake Adjustment (2500/3500 SRW)  or Parking Brake Adjustment (3500 DRW) .
scientia non olet · About LEMON Manuals