Instrument Panel Electrical Center or Junction Block Replacement - Left Side

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Left I/P Electrical Center/Junction Block

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the instrument panel (I/P) knee bolster. Refer to Knee Bolster Replacement (With SLT) or Knee Bolster Replacement (Without SLT) .
1	Left I/P Electrical Center/Junction Block Procedure Disconnect all electrical connections. Release the plastic retaining tab to loosen the electrical center and maneuver out of I/P area.

Callout

Component Name

Preliminary Procedure:
Remove the instrument panel (I/P) knee bolster. Refer to Knee Bolster Replacement (With SLT) or Knee Bolster Replacement (Without SLT) .

Left I/P Electrical Center/Junction Block

Procedure

Disconnect all electrical connections.
Release the plastic retaining tab to loosen the electrical center and maneuver out of I/P area.