LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1705 (Automatic Transmission - 2MT70 - DTC P0965 To DTC P2730) >> DTC P2714 or P2715 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the Transmission Fluid Check .
  2. Turn ON the ignition, with the engine OFF.
    3. NOTE: Before clearing the DTC, use the scan tool in order to record the Freeze Frame and Failure Records.
  3. Record the DTC Freeze Frame and Failure Records.
  4. Clear the DTC.
  5. Perform the Transmission Fluid Check to verify correct fluid level and condition. The transmission fluid level should be within the crosshatch band and the transmission fluid should be red or dark brown.
  6. Engine idling at operating temperature. Attempt to clean or free up a potential sticking valve with the scan tool Service Cleaning Procedure. Refer to Control Solenoid Valve and Transmission Control Module Assembly Cleaning for further instructions.
  7. Operate the vehicle in drive with the calc. throttle position greater than 15 percent to obtain 72 km/h (45 mph) and achieve 4th gear. Stop the vehicle and turn Off the ignition for 30 seconds. Perform this maneuver 2 times.
    • If the DTC resets, go to Circuit/System Testing.
scientia non olet · About LEMON Manuals