LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 396 (Engine Cooling - 3.3L DURATEC-V6) >> Removal And Installation >> Cooling Module >> Installation

Cooling Module: Installation

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. NOTE: Only use the specified material to lubricate the seals.

    Install new condenser fitting O-ring seals.

    Material

    : Motorcraft® R-1234yf Refrigerant PAG Oil / YN-35 (WSS-M2C300-A2)

  3. Fill and bleed the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
  4. Check and fill the transmission fluid. Refer to: Transmission Fluid Level Check (10R80) . Refer to: Transmission Fluid Level Check (6R80) .
scientia non olet · About LEMON Manuals