Pinpoint Test E: A Single Power Window Is Inoperative - RH (Right-Hand) Front
- Refer to POWER WINDOWS
for schematic and connector information.
Normal Operation and Fault Conditions
Possible Sources
- Wiring, terminals or connectors
- Master window control switch
- RH front window control switch
- RH front window regulator motor
- E1 CHECK THE RH WINDOW CONTROL SWITCH POWER CIRCUIT FOR AN OPEN
- Ignition OFF.
- Disconnect: RH Front Window Control Switch C643.
- Ignition ON.
- Measure:
Positive Lead Measurement / Action Negative Lead C643-2 Ground
Is the voltage greater than 11 volts?
Yes GO to E2 No REPAIR the circuit. - E2 CHECK THE MASTER WINDOW CONTROL SWITCH NORMALLY CLOSED GROUND CIRCUITS FOR AN OPEN
- Ignition OFF.
Are the resistances less than 3 ohms?
Yes GO to E4 No GO to E3 - E3 CHECK THE POWER WINDOW CONTROL CIRCUITS FOR AN OPEN
- Disconnect: Master Window Control Switch C504B.
- If equipped with power rear windows, measure:
Positive Lead Measurement / Action Negative Lead C504B-7 C643-6 C504B-8 C643-3
Are the resistances less than 3 ohms?
Yes INSTALL a new master window control switch. REFER to: Front Door Window Control Switch . No REPAIR the circuit in question. - E4 CHECK THE POWER WINDOW UPWARD AND/OR DOWNWARD OPERATION
- Ignition ON.
- To check downward window operation, connect fused jumper wires:
Positive Lead Measurement / Action Negative Lead C643-2 C643-7 C643-6 C643-1
- To check upward window operation, connect fused jumper wires:
Positive Lead Measurement / Action Negative Lead C643-2 C643-1 C643-6 C643-7
Does the RH front window move up and/or down?
Yes REMOVE the jumper wires. If the RH front window did not operate from the RH front window control switch, INSTALL a new RH window control switch. REFER to: Front Door Window Control Switch . If the RH front window did not operate from the master window control switch, INSTALL a new master window control switch. REFER to: Front Door Window Control Switch . No REMOVE the jumper wires. GO to E5 - E5 CHECK THE POWER WINDOW CIRCUITS FOR AN OPEN
- Ignition OFF.
- Disconnect: RH Front Power Window Motor C608.
Are the resistances less than 3 ohms?
Yes MAKE SURE there are no mechanical binding conditions preventing the glass mechanism from operating correctly. If a mechanical binding issue is found, REPAIR as necessary. If no mechanical binding condition exists, INSTALL a new RH front window regulator motor. REFER to: Front Door Window Regulator Motor . No REPAIR the circuit in question.