Pinpoint Test B: P0504, P0572, P0573, P1703 Or P1935: Notes
Refer to Cruise Control for schematic and connector information.
Refer to Turn Signal/Stop/Hazard Lamps for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Cruise Control - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0504 | Brake Switch A / B Correlation | This DTC sets when the PCM does not sense the correct sequence of brake pedal input signals from the cruise control deactivator and stoplamp switches when the brake pedal is applied and released. |
| P0572 | Brake Switch A Circuit Low | This DTC sets when the PCM detects an open in the stoplamp switch signal circuit. The PCM monitors vehicle speed, engine speed, engine torque and the stoplamp input during start and stop driving. If the stoplamp switch input to the PCM is always off during start and stop driving, this DTC sets in continuous memory. |
| P0573 | Brake Switch A Circuit High | This DTC sets when the PCM detects a short to voltage on the stoplamp switch signal circuit. The PCM monitors vehicle speed, engine speed, engine torque and the stoplamp switch input during start and stop driving. If the stoplamp lamp switch input to the PCM is always on during start and stop driving, this DTC sets in continuous memory. |
| P1703 | Brake Switch Out Of Self - Test Range | This DTC sets in the PCM during the self-test when the stoplamp switch input signal is high or does not cycle high and low. |
| P1935 | Brake Switch/Sensor Signal | This DTC sets in the PCM when the PCM does not receive the brake switch input to deactivate the cruise control. |
Possible Sources
- Wiring, terminals or connectors
- Stoplamp switch
- PCM