LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Transfer Case - 3.5L DURATEC (212KW/278PS)) >> Removal And Installation >> Transfer Case Input Shaft Seal >> Installation

Transfer Case Input Shaft Seal: Installation

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the PTU input shaft opening.
    GFD282018Courtesy of FORD MOTOR COMPANY
  2. Position the inner seal above the PTU input shaft opening with the spring facing toward the PTU. Using the special tools, install the seal. Use Special Service Tool: 205-153 (T80T-4000-W) Handle, 308-777 Remover and Installer, PTU Input Shaft Seal.
    GFD281973Courtesy of FORD MOTOR COMPANY
  3. Position the outer seal above the PTU input shaft opening with the spring facing away from the PTU. Using the special tools, install the seal. Use Special Service Tool: 205-153 (T80T-4000-W) Handle, 308-777 Remover and Installer, PTU Input Shaft Seal.
    GFD281974Courtesy of FORD MOTOR COMPANY
  4. Install the new compression seal.
    GFD282019Courtesy of FORD MOTOR COMPANY
  5. Install the PTU. Refer to: Transfer Case .
  6. Fill the PTU as necessary. Refer to: Transfer Case Draining and Filling .
  7. Check and top off the transmission. Refer to: Transmission Fluid Level Check .
scientia non olet · About LEMON Manuals