Pinpoint Test H : The RH (Right-Hand) Rear Power Fold Seat Is Inoperative

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

H1 CHECK THE SECOND ROW REAR SEAT MOTOR GROUND

Ignition OFF.

Disconnect RH Second Row Rear Seat Motor C3346.

Ignition ON.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C3346-2	Courtesy of FORD MOTOR COMPANY	Ground

Is the resistance less than 3 ohms?

Yes

GO to H2

No	REPAIR the circuit.

H2 CHECK FOR VOLTAGE TO THE SECOND ROW REAR SEAT MOTOR

Ignition ON.

While pressing and holding the RH second row seat control switch, measure:

Positive Lead	Measurement / Action	Negative Lead
C3346-1	Courtesy of FORD MOTOR COMPANY	C3346-2

Is the voltage greater than 11 volts while the second row seat control switch is pressed?

Yes	INSTALL a new RH second row seat motor. REFER to: Power Fold Seat Motor .

GO to H3

H3 CHECK THE SECOND ROW REAR SEAT MOTOR CIRCUIT FOR AN OPEN

Ignition OFF.

Disconnect Second Row Seat Control Switch C4512.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C3346-1	Courtesy of FORD MOTOR COMPANY	C4512-5

Is the resistance less than 3 ohms?

Yes	INSTALL a new second row seat control switch. REFER to: Power Fold Seat Control Switch .

No	REPAIR the circuit.