DTC Charts
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: DIAGNOSTIC METHODS .
for information about these practices.
PCM DTC CHART
| DTC | Description | Action |
|---|---|---|
| PCM Diagnostic Trouble Codes (DTCs) | PCM Diagnostic Trouble Codes (DTCs) not listed in this chart | For 1.6L EcoBoost, REFER to: ELECTRONIC ENGINE CONTROLS - 1.6L EcoBoost (132kW/180PS) - Sigma . For 2.0L EcoBoost, REFER to: ELECTRONIC ENGINE CONTROLS - 2.0L EcoBoost (184kW/250PS) - MI4 . For 2.5L Duratec, REFER to: ELECTRONIC ENGINE CONTROLS - 2.5L Duratec (125kW/170PS) . |
| P0562 | System Voltage Low | GO to PINPOINT TEST B |
| P0563 | System Voltage High | GO to PINPOINT TEST A |
| P0620 | Generator Control Circuit | GO to PINPOINT TEST H |
| P0625 | Generator Field Terminal Circuit Low | GO to PINPOINT TEST I |
| P0626 | Generator Field Terminal Circuit High | GO to PINPOINT TEST I |
| P065C | Generator Mechanical Performance | GO to PINPOINT TEST C |
| P0A5A | Generator Current Sensor Circuit Range/Performance | GO to PINPOINT TEST G |
| P0A5B | Generator Current Sensor Circuit Low | GO to PINPOINT TEST G |
| P0A5C | Generator Current Sensor Circuit High | GO to PINPOINT TEST G |
| P1397 | System Voltage Out Of Self-Test Range | If combined with P0562, GO to PINPOINT TEST B If combined with P0563, GO to PINPOINT TEST A |
BCM DTC CHART
| DTC | Description | Action |
|---|---|---|
| BCM Diagnostic Trouble Codes (DTCs) | BCM Diagnostic Trouble Codes (DTCs) not listed in this chart | REFER to: BODY CONTROL MODULE (BCM) . |
| B11DB:02 | Battery Monitoring Module "A", General Signal Failure | GO to PINPOINT TEST F |
| B11DB:08 | Battery Monitoring Module "A", Bus Signal/Message Failure | GO to PINPOINT TEST F |
| B11DB:11 | Battery Monitoring Module "A", Circuit Short To Ground | GO to PINPOINT TEST F |
| B11DB:49 | Battery Monitoring Module "A", Internal Electronic Failure | CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the BCM
self test. If Diagnostic Trouble Codes (DTCs) B11DB:49 is retrieved, INSTALL new Battery Monitoring Sensor. REFER to: BATTERY MONITORING SENSOR . |
| B11DB:55 | Battery Monitoring Module "A", Not Configured | Perform Battery Monitoring System Reset using the scan tool. If the DTC
returns, replace the Battery Monitoring Sensor. REFER to: BATTERY MONITORING SENSOR . |
| B11DB:9A | Battery Monitoring Module "A", Component or System Operating Conditions | GO to PINPOINT TEST F |
| B130C:12 | Load Shed Control Circuit Short To Battery | GO to PINPOINT TEST E |
| B130C:14 | Load Shed Control Circuit Short To Ground or Open | GO to PINPOINT TEST E |
| B1438:03 | Battery Current Sensor, FM /PWM Failure | GO to PINPOINT TEST E |
| U1007:31 | Lost Communication With Battery Monitoring Sensor "A": No Signal | GO to PINPOINT TEST F |