LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fusion Titanium, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Column Electrical Components (Except Hybrid) >> Diagnosis and Testing >> Steering Wheel and Column Electrical Components >> Symptom Chart >> Symptom Chart: Steering Column Switches

Symptom Chart: Steering Column Switches

Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: DIAGNOSTIC METHODS .

SYMPTOM CHART

Condition Possible Sources Actions
No power in all ignition switch positions - conventional ignition switch Refer to PINPOINT TEST  GO to PINPOINT TEST A 
No power in ACC - conventional ignition switch Refer to PINPOINT TEST  GO to PINPOINT TEST B 
No power in RUN - conventional ignition switch Refer to PINPOINT TEST  GO to PINPOINT TEST C 
No power in START - conventional ignition switch Refer to PINPOINT TEST  GO to PINPOINT TEST D 
No power in ON - push button ignition switch Refer to PINPOINT TEST  GO to PINPOINT TEST E 
Key not detected is displayed in the message center
  • Wiring, terminals or connectors
  • Passive key
  • PATS  antennas
  • RTM  module
 REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) .
The ignition key cannot be returned to the OFF position Refer to PINPOINT TEST  GO to PINPOINT TEST F 
The ignition key can be turned to the OFF position when the selector lever is not in PARK Refer to PINPOINT TEST  GO to PINPOINT TEST G 
The ignition key is hard to turn
  • Ignition lock cylinder
  • Ignition key
  • Ignition switch
 REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS .
The multifunction switch does not operate correctly
  • Multifunction switch
 REFER to: AUTOLAMPS .
The wiper and washer switch does not operate correctly
  • Wiper and washer switch
 REFER to: WIPERS AND WASHERS .
scientia non olet · About LEMON Manuals