BCM DTC Chart
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: DIAGNOSTIC METHODS .
| DTC | Description | Action |
|---|---|---|
| B108A:01 | Start Button: General Electrical Failure | GO to PINPOINT TEST E |
| B108A:24 | Start Button: Signal Stuck High | GO to PINPOINT TEST E |
| B1142:29 | Ignition Status 1: Signal Invalid | For vehicles equipped with an ignition switch, GO to PINPOINT TEST C For vehicles equipped with push button start, GO to PINPOINT TEST E |
| B1240:11 | Start Button Mode Indicator: Circuit Short to Ground | REFER to: INSTRUMENT PANEL CLUSTER (IPC) AND PANEL ILLUMINATION . |
| B1240:15 | Start Button Mode Indicator: Circuit Short to Battery or Open | REFER to: INSTRUMENT PANEL CLUSTER (IPC) AND PANEL ILLUMINATION . |
| B130F:12 | Run Accessory Control: Circuit Short to Battery | REFER to: WIPERS AND WASHERS . |
| B130F:14 | Run Accessory Control: Circuit Short to Ground or Open | REFER to: WIPERS AND WASHERS . |
| B1310:12 | Run/Start Control: Circuit Short to Battery | GO to PINPOINT TEST J |
| B1310:14 | Run/Start Control: Circuit Short to Ground or Open | For vehicles equipped with an ignition switch, GO to PINPOINT TEST C For vehicles equipped with push button start, GO to PINPOINT TEST E |
| U0212:87 | Lost Communication With Steering Column Control Module: Missing Message | REFER to: BODY CONTROL MODULE (BCM) . |
| U300A:01 | Ignition Switch: General Electrical Failure | GO to PINPOINT TEST A |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: BODY CONTROL MODULE (BCM) . |