LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Engine Controls - System & Engine Component Tests - 6.0L (99P F450/550) Diesel) >> Hard Start/No-Start Diagnostic Procedures >> Test 10B: Check Rpm Signal While Cranking >> Recommended Procedure

Recommended Procedure

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Connect scan tool to Data Link Connector (DLC). Using scan tool, access RPM PID from PID/DATA MONITOR & RECORD menu. Crank engine while monitoring RPM PID reading. See PID PARAMETERS  table. If RPM PID reading indicates less than 100 RPM, check CMP sensor circuit. See TEST V: CAMSHAFT POSITION SENSOR under SYSTEM TESTS in SELF-DIAGNOSTICS - 6.0L DIESEL article.

scientia non olet · About LEMON Manuals