LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Windstar Base, Van Passenger >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panels - Analog >> Self-Diagnostic System >> Retrieving Codes (Dealer Test Mode) >> Entering Dealer Test Mode

Entering Dealer Test Mode

  1. Depress and hold instrument cluster trip odometer/reset button. Turn ignition switch to ON position. Continue pressing trip odometer/reset button until "tESt" is displayed in odometer.
  2. Trip odometer/reset button must be released within 3 seconds of odometer displaying "tESt" to begin dealer test mode.
  3. If no codes were displayed using scan tool, depress trip odometer/reset button to advance through following modes until "dtc" is displayed. Depressing trip odometer/reset button will display any continuous DTC stored. If any DTC are stored, perform appropriate test in accordance with DTCs retrieved. See INSTRUMENT CLUSTER DTC INDEX  table under RETRIEVING CODES (SCAN TOOL).
  4. If no codes are stored, the following modes can be used to actuate instrument cluster displays. Depress trip odometer/reset button to advance through test modes. See DEALER TEST MODE DISPLAYS .
scientia non olet · About LEMON Manuals