LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission - Diagnosis - Cd4E) >> Diagnosis & Testing >> Reading Diagnostic Trouble Codes >> Continuous Memory Codes (Intermittent Faults)

Continuous Memory Codes (Intermittent Faults)

WARNING: This page is about a different variant/trim than selected.
CAUTION: Continuous memory codes should be recorded when retrieved. These DTCs may be used to identify intermittent faults that exist after all KOEO and KOER DTCs have been repaired. Some continuous memory code faults may not be valid after KOEO and KOER DTCs are serviced.

These DTCs result from information stored by PCM during continuous self-test monitoring. Use these DTCs for diagnosis only when KOEO SELF-TEST and KOER SELF-TEST result in SYSTEM PASS and all steps in QUICK TEST are successfully completed. These DTCs indicate faults previously recorded. Fault may or may not be currently present. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table. After noting and/or repairing concern, clear codes from memory. See CLEARING DIAGNOSTIC TROUBLE CODES . Intermittent faults may be caused by a sensor, connector or wiring-related concern.

DIAGNOSTIC TROUBLE CODE IDENTIFICATION

DTC (1) Code Definition System Test
P0707 TR Sensor Circuit Shorted D 
P0708 TR Sensor Circuit Open D 
P0712 TFT Sensor Circuit Shorted B 
P0713 TFT Sensor Circuit Open B 
P0715 Insufficient Input From TSS Sensor F 
P0717 No TSS Sensor Signal Detected F 
P0718 TSS Sensor Circuit Intermittent F 
P0720 Insufficient OSS Sensor Signal F 
P0721 Noisy OSS Sensor Signal F 
P0722 OSS Sensor Signal Intermittent F 
P0731 No 1st Gear A 
P0732 No 2nd Gear A 
P0733 No 3rd Gear A 
P0734 No 4th Gear A 
P0743 TCC Circuit Error C 
P0750 SS1 Solenoid Circuit Failure A 
P0751 SS1 Functional Failure A 
P0755 SS2 Solenoid Circuit Failure A 
P0756 SS2 Functional Failure A 
P1702 TR Sensor Circuit Intermittent D 
P1705 TR Sensor Not In Park D 
P1711 TFT Sensor Out Of Range B 
P1713 TFT Sensor In Low Failure B 
P1714 SS1 Mechanical Failure Detected (2)
P1715 SS2 Mechanical Failure Detected (2)
P1718 TFT Sensor In High Failure B 
P1742 TCC Solenoid Failed On C 
P1744 TCC/Excessive Slip Detected C 
P1746 Open PCM Output Driver E 
P1747 EPC Solenoid Circuit Failure E 
P1751 SS1 Functional Failure A 
P1756 SS2 Functional Failure A 
P1783 Transaxle Overheating B 
P1788 3-2T/CCS Solenoid Circuit Failure G 
P1789 3-2T/CCS Solenoid Circuit Failure G 
(1) For complete list of engine performance fault codes, see appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
(2) Perform TRANSMISSION DRIVE CYCLE TEST . After testing, if concern is still present, replace PCM.