LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission - Diagnosis - Cd4E) >> Diagnosis & Testing >> Transmission Drive Cycle Test

Transmission Drive Cycle Test

WARNING: This page is about a different variant/trim than selected.
NOTE: The transmission drive cycle test must be followed exactly. Malfunctions have to occur 4 times consecutively for continuous memory codes P0731, P0732, P0733 and P0734 to set, and 5 times consecutively for continuous memory codes P0741 and P1741 to set.
  1. After repairing any engine performance-related DTCs, erase remaining transaxle-related DTCs. Warm engine to normal operating temperature. Ensure transaxle fluid level is correct. Place gearshift lever in "D" position. Press TCS on shifter handle. O/D OFF light should illuminate.
  2. Accelerate from stop to 40 MPH. Hold speed for at least 15 seconds (30 seconds above 4000 ft.). Press TCS and accelerate to 50 MPH. Hold speed for at least 15 seconds (30 seconds above 4000 ft.). While maintaining speed with transaxle in 4th gear, lightly depress brake pedal and release. Hold speed for at least an additional 5 seconds. Bring vehicle to stop for at least 20 seconds with transaxle in "D" position. Repeat steps 1)  and 2)  at least 5 times. Perform QUICK TEST  and record continuous memory codes.
scientia non olet · About LEMON Manuals