Section 1782 (Engine Controls - Diagnostic Methods (Except Diesel & Hybrid))
WARNING: This page does not describe the selected car, but rather 29 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnostic Methods
- Diagnostic Tools
- Scan Tool Setup and Functionality
- Vehicle Check/Preparation
- Quick Test Description
- Clear the Continuous Diagnostic Trouble Codes (DTCs) and Reset the Emission Monitors Information in the Powertrain Control Module (PCM)
- Resetting The Keep Alive Memory (KAM)
- On-Board System Readiness (OSR) Test
- Output State Control (OSC)
- Output Test Mode (OTM)
- Parameter Identification (PID)
- Freeze Frame Data
- Flash Electrically Erasable Programmable Read Only Memory (EEPROM)
- Diagnostic Monitoring Test Results - Mode 6
- On Board Diagnostic (OBD) Drive Cycle
- Intermittent Diagnostic Techniques
- Adaptive Fuel DTC Diagnostic Techniques
- Notes
- Obtain Freeze Frame Data
- Using the LONGFT1 and LONGFT2 (Dual Bank Engines) PIDs
- Resetting Long Term Fuel Trims
- DTCs P0171/P0174 System Too Lean Diagnostic Aids
- Air Measurement System
- Vacuum Leaks/Unmetered Air
- Insufficient Fueling
- Exhaust System Leaks
- DTCs P0172/P0175 System Too Rich Diagnostic Aids
- Fuel System
- Air Inlet System
- Base Engine