Air Measurement System

WARNING: This page does not describe the selected car, but rather 29 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.

With this condition, the engine runs rich or lean of stoichiometry (14.7:1 air/fuel ratio) if the powertrain control module (PCM) is not able to compensate enough to correct for the condition. One possibility is that the mass of air entering the engine is actually greater than what the MAF sensor is indicating to the PCM. For example, with a contaminated MAF sensor, the engine runs lean at higher RPM because the PCM delivers fuel for less air than is actually entering the engine. Examples:

The MAF sensor measurement is inaccurate due to a corroded connector, contaminated or dirty connector. A contaminated MAF sensor typically results in a rich system at low airflows (PCM reduces fuel) and a lean system at high airflows (PCM increases fuel).

With this condition, the engine runs rich or lean of stoichiometry (14.7:1 air/fuel ratio) if the PCM is not able to compensate enough to correct for the condition. One possibility is that the mass of air entering the engine is actually less than what the MAF sensor is indicating to the PCM. For example, with a contaminated MAF sensor, the engine runs rich at idle because the PCM delivers fuel for more air than is actually entering the engine. Examples:

MAF sensor measurement inaccurate due to a corroded connector, contamination/dirt. A contaminated MAF sensor typically results in a rich system at low airflows (PCM reduces fuel) and a lean system at high airflows (PCM increases fuel).