LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine - 4.9L 6-CYL - VIN [Y]) >> Removal & Installation >> Timing Gears >> Installation

Timing Gears: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1996 Ford Pickup, 1996 Ford Econoline, 1996 Ford Club Wagon, 1996 Ford Cab & Chassis, and 1995 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure camshaft key spacer and thrust plate are correctly aligned. Install Woodruff key into camshaft. Align camshaft gear keyway with camshaft key, and install gear using Camshaft Gear Replacing Adapter (T65L-6306-A).
  2. Install Woodruff key into crankshaft. Using Crankshaft Damper Replacer (T52L-6306-AEE), install crankshaft gear. Ensure timing marks on camshaft and crankshaft gears are still aligned.
  3. To complete installation, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS . Fill or top off all fluids. Fill and bleed air from cooling system. Refer to COOLING SYSTEM BLEEDING .
Fig 1: Aligning Timing Marks
G93H75868Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals