LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine - 4.9L 6-CYL - VIN [Y]) >> Removal & Installation >> Cylinder Head >> Inspection

Cylinder Head: Inspection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1996 Ford Pickup, 1996 Ford Econoline, 1996 Ford Club Wagon, 1996 Ford Cab & Chassis, and 1995 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean gasket mating surfaces. Check cylinder head warpage. Resurface cylinder head if warpage exceeds specification. Refer to CYLINDER HEAD  table under ENGINE SPECIFICATIONS. Check cylinder block deck surface for warpage.
  2. Resurface cylinder block if warpage exceeds specification. See CYLINDER BLOCK  table under ENGINE SPECIFICATIONS. If cylinder head or cylinder block warpage exceeds specification, DO NOT remove more than .010" (.25 mm) material from original surface of cylinder head or block.
scientia non olet · About LEMON Manuals