LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Durango R/T, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lamps/Lighting - Exterior (Service Information) >> Unit, Front Lamp >> Removal >> Front Park And Turn Signal

Front Park And Turn Signal

WARNING:

To avoid serious or fatal injury when working on the High Intensity Discharge (HID) headlamp system, be certain to take the proper precautions. The headlamp switch must be in the OFF position. Disconnect and isolate the battery negative cable. There is a risk of fatal injury caused by contact with high voltage used in the HID headlamps. There is a risk of explosion or fire caused by highly flammable materials in the vicinity of damaged HID lighting elements. There is a risk of injury caused by exposure to Ultra Violet (UV) light, a risk of burns caused by high component operating temperatures, a risk of mercury poisoning through glass splinters produced by bursting HID lighting elements. There is also a risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with the skin. Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on HID headlamps. Wear insulated safety shoes, safety glasses and protective gloves. Remove flammable materials and ensure sufficient ventilation in the working area.

FOR LED:  The turn signal and park LED lamps are built into the front headlamp assembly. Replacement of the front headlamp assembly is required. Refer to UNIT, FRONT LAMP, REMOVAL .

LEFT SIDE 

  1. Disconnect and isolate the negative battery cable.
  2. Remove the air cleaner housing only. Refer to REMOVAL or Refer to REMOVAL or Refer to BODY, AIR CLEANER, REMOVAL .
  3. If replacing the turn signal lamp, disconnect the electrical connector from the back of the lamp. If only replacing the bulb, proceed to step 4.
  4. Grab the base of the turn signal lamp and rotate counter clockwise to loosen and remove from the front lamp unit housing.
  5. If replacing the bulb, remove the bulb from the lamp socket.

RIGHT SIDE 

  1. Disconnect and isolate the negative battery cable.
  2. Reach beneath the coolant overlow bottle to access the turn signal lamp and socket.
  3. If replacing the turn signal lamp, disconnect the electrical connector from the back of the lamp. If only replacing the bulb, proceed to step 4.
  4. Rotate the lamp socket counter clockwise to loose and remove from the front lamp housing.
  5. If replacing the bulb, remove the bulb from the lamp socket.
scientia non olet · About LEMON Manuals