LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Durango Pursuit >> Repair and Diagnosis >> Electrical >> Gauges >> Body - Interior & Exterior >> Interior >> Headliner >> Removal

Body - Interior & Exterior: Interior: Headliner: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable. Wait two minutes for the system capacitor to discharge before further service.
  2. Remove the front overhead console. Refer to CONSOLE, OVERHEAD, FRONT, REMOVAL .
  3. Remove the four grab handles. Refer to HANDLE, GRAB, ROOF, REMOVAL .
  4. Remove the coat hooks. Refer to HOOK, COAT, REMOVAL .
  5. Remove the visors. Refer to VISOR, REMOVAL .
    GC0146127Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the front electrical connector (2) and separate the wire harness (1) from the A-pillar.
    GC0146128Courtesy of CHRYSLER GROUP, LLC
  7. Remove the A-pillar trim panels. Refer to PANEL, A-PILLAR TRIM, REMOVAL .
  8. Remove the B-pillar trim panels. Refer to PANEL, B-PILLAR TRIM, UPPER, REMOVAL .
  9. Remove the C-pillar trim panels. Refer to PANEL, C-PILLAR TRIM, REMOVAL .
  10. Remove the D-pillar trim panels. Refer to PANEL, D-PILLAR TRIM, REMOVAL .
  11. Disconnect the rear electrical connectors (1).
  12. Remove the two rear push pin fasteners (2).
    GC0145478Courtesy of CHRYSLER GROUP, LLC
  13. For vehicles with a sunroof, separate the hook and loop fasteners (2) around the outside of the sunroof opening.
    CAUTION:

    Be careful not to crease the headliner.

  14. Disconnect all electrical connectors and the washer solvent hose.
  15. With a helper, remove the headliner through the liftgate opening.
scientia non olet · About LEMON Manuals