Section 95 (6.7L Diesel - Mil Light On Pretest Procedure, Diesel AFTERTREATMENT Validation, Pre-Diagnostic Troubleshooting Procedure, Pcm/ECM/TCM Programming, Powertrain Verification Test & Intermittent Condition - 2500 & 3500)
WARNING: This page is about a different car, the 2011 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Standard Procedure
- Mil Light On Pretest Procedure
- Diesel AFTERTREATMENT Validation- 6.7L
- Pre-Diagnostic Troubleshooting Procedure - 6.7L
- Pcm/ECM / TCM Programming
- Pcm/ECM / TCM Flash PROGRAMING
- Table Of Contents
- Section 1 - Pcm/ECM / TCM Flash Procedure
- REPAIR PROCEDURE - Using StarSCAN® or StarMOBILE® Desktop Client
- REPAIR PROCEDURE - wiTECH™ Diagnostic Application
- Section 2 - Additional Pcm/ECM / TCM Replacement Procedures
- Notes
- If a 2.0L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a PT Cruiser, 2.2L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a 3.0L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a 2.8L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a PM/MK, 2.2L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a 5.9L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a 6.7L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If an Aisin TCM was replaced, perform the following additional steps and/or routines:
- If an EATX TCM was replaced, perform the following additional steps and/or routines:
- If an NGC3 TCM ONLY was replaced, perform the following additional steps and/or routines:
- If an NGC4 TCM ONLY was replaced, perform the following additional steps and/or routines:
- If an EGS TCM was replaced, perform the following additional steps and/or routines:
- Step-By-Step Instructions
- PCM/ECM Replaced
- Check PCM VIN
- Diesel Particulate Filter (Used) Learning
- ECU Replacement with Value Transfer
- ECU Replacement without Value Transfer
- Enable / Disable Vehicle Features
- Exhaust Throttle Plate Adaptive Learn Position
- Fuel Mean Value Adaptation Initialization
- IMA Rapid Calibration
- Initialize EGS
- Injector Quantity Adjustment
- Mobile DeSoot - NO Minimum Required Soot Load
- NOx Catalyst (New) Initialization
- Program Variant Code
- Quicklearn
- Reset Regenerative Filter Timers
- Set Oil Dilution Mass Value
- Section 3 - Authorized MODIFCATION Label
- Required Tools / Equipment:
- TECH TIPS and INFORMATION:
- Parts Required
- Powertrain Verification Test - 6.7L
- Intermittent Condition - 6.7L