LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Engine Block >> Crankshaft >> Removal

Engine Block: Crankshaft: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate both of the negative battery cables.
  2. Remove the engine from vehicle and mount on a suitable engine stand. Refer to REMOVAL, 6.7L .
    GC0155289Courtesy of CHRYSLER GROUP, LLC
  3. Remove the bolts (3) and the oil pan (2).
    GC0155173Courtesy of CHRYSLER GROUP, LLC
  4. Remove the bolts (2 and 3) and the oil pickup tube (1).
    GC0169692Courtesy of CHRYSLER GROUP, LLC
  5. Remove the bolts (1) and the block stiffener (2).
  6. Remove the front timing case housing. Refer to HOUSING, TIMING CASE, FRONT, REMOVAL, 6.7L .
  7. Remove the crankshaft rear oil seal retainer. Refer to RETAINER, CRANKSHAFT REAR OIL SEAL, REMOVAL, 6.7L .
    GC0155211Courtesy of CHRYSLER GROUP, LLC
  8. Remove the bolts (3) and the connecting rod bearing cap for each piston.
  9. Remove the bolts (2) and the crankshaft main bearing caps.
    GC0155124Courtesy of CHRYSLER GROUP, LLC
  10. Carefully remove the crankshaft (3) from the engine block (1).
  11. If required, remove the timing gear from the crankshaft.
scientia non olet · About LEMON Manuals