LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Engine Block >> Retainer, Crankshaft Rear Oil Seal >> Removal

Retainer, Crankshaft Rear Oil Seal: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate both of the negative battery cables.
  2. Remove the transmission adapter plate. Refer to PLATE, TRANSMISSION ADAPTER, REMOVAL, 6.7L .
    GC0155141Courtesy of CHRYSLER GROUP, LLC
  3. Remove four rear oil pan bolts 29 - 32. Slide a feeler gauge between the seal retainer and oil pan gasket to break the seal.
  4. Loosen the 12 rear oil pan bolts 1, 4, 7 - 10, 15 - 18, 27 - 28. Then slightly pry down on the rear of the oil pan.
    GC0108553Courtesy of CHRYSLER GROUP, LLC
  5. Remove the bolts (3), the rear seal retainer (1).
  6. Remove and discard gasket (2).
  7. Support the seal retainer and drive out the crankshaft seal with a hammer and suitable punch.
scientia non olet · About LEMON Manuals