LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Valve Timing >> Housing, Timing Case, Front >> Removal

Housing, Timing Case, Front: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate both of the both negative battery cables.
  2. Remove the camshaft. Refer to REMOVAL .
  3. Remove the power steering pump. Refer to PUMP, REMOVAL .
  4. Remove the fuel injection pump. Refer to PUMP, FUEL INJECTION, REMOVAL .
  5. Remove the crankshaft position sensor. Refer to SENSOR, CRANKSHAFT POSITION, REMOVAL .
    GC0155254Courtesy of CHRYSLER GROUP, LLC
  6. Remove the front six oil pan bolts (1).
    GC0155250Courtesy of CHRYSLER GROUP, LLC
  7. Remove the front timing case housing bolts (1, 2).
    NOTE:

    Use care when removing the front timing case housing, to avoid damage to the oil pan gasket.

  8. Slide a feeler gauge between the front timing case housing and oil pan gasket, to break the gasket seal.
  9. Remove the front timing case housing and gasket.
  10. Clean the gasket material from the cylinder block and front timing case housing.
scientia non olet · About LEMON Manuals