LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1568 (Front Suspension & Wheel Alignment - 2500 Hd) >> Front, Link And Coil >> Knuckle, Steering >> Removal

Knuckle, Steering: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hub bearing. Refer to HUB AND BEARING, REMOVAL .
  2. Remove tie-rod or drag link end from the steering knuckle arm.
  3. Remove the wheel speed sensor. Refer to SENSOR, WHEEL SPEED, FRONT, REMOVAL .
  4. Loosen the upper ball stud nut.Do not remove the nut at this time. 
  5. Remove the lower ball joint nut.
    GC0107544Courtesy of CHRYSLER GROUP, LLC
  6. Separate the lower ball joint (4) using Ball Joint Press (special tool #C-4150A, Press, Ball Joint) (3).
  7. Remove the upper ball joint nut.
  8. Remove the steering knuckle (2).
scientia non olet · About LEMON Manuals