LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1568 (Front Suspension & Wheel Alignment - 2500 Hd) >> Front, Link And Coil >> Hub And Bearing >> Removal

Hub And Bearing: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the wheel and tire assembly.
    GC0107537Courtesy of CHRYSLER GROUP, LLC
  3. Remove the hub extension (1) mounting nuts and remove the extension from the rotor if equipped.
    GC0155475Courtesy of CHRYSLER GROUP, LLC
  4. Remove the brake caliper. Refer to CALIPER, DISC BRAKE, REMOVAL .
  5. Remove the hub nut (1) from the axle shaft.
  6. Remove the caliper adapter. Refer to ADAPTER, DISC BRAKE CALIPER, REMOVAL .
  7. Remove the disc brake rotor. Refer to ROTOR, BRAKE, REMOVAL .
  8. Disconnect the wheel speed sensor wire.
    GC0107541Courtesy of CHRYSLER GROUP, LLC
  9. Loosen the hub/bearing 4 mounting bolts (1).
    GC0155200Courtesy of CHRYSLER GROUP, LLC
  10. Using (special tool #10415, Remover, Front Hub) and a pry bar (2), place the tool (1) onto the hub/bearing mounting bolts to separate the hub/bearing from the knuckle assembly.
  11. Remove the hub/bearing 4 mounting bolts and remove the hub/bearing.
scientia non olet · About LEMON Manuals