Sensor, Wheel Speed, Front: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - WHEEL SPEED SENSOR MOUNTING BOLT |
| 2 - WHEEL SPEED SENSOR |
| 3 - HUB/BEARING |
- Remove the front rotor. Refer to ROTOR, BRAKE, REMOVAL .
- Remove the wheel speed sensor mounting bolt (1) from the hub (3).
- Remove the wheel speed sensor (2) from the hub (3).
- Remove the wiring from the clips and disconnect the electrical connector.NOTE:
Do not reuse wiring harness routing clips, they must be replaced if removed from the mounting holes.