Ball Joint, Suspension, Lower: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the steering knuckle. Refer to KNUCKLE, STEERING, REMOVAL .
- Remove the axle shaft from the axle. Go to REMOVAL
.
- Position Ball Joint Remover/Installer (special tool #10510B, Receiver, Ball Joint) (RECEIVER) (2) and Ball Joint Remover/Installer (special tool #8975-4, Remover, Ball Joint) (DRIVER) (4) with Ball Joint Press (special tool #C-4212F, Press, Ball Joint) (1) as shown to remove lower ball stud.