Ram Box Lamps

The Ram Box storage bins located in each bed rail of the pickup box, are an integral part of the Ram Box storage and organization option for this vehicle. Each storage bin has integral interior lighting features.

• Lamps  - Each storage bin has two interior lamps, both are in the lid of the storage bin. Each of these lamps includes a sealed, non-removable lens and has an integral interlocking tab mounting feature on one end and an integral latch feature at the opposite end that are used to secure the lamps in the mounting holes in the lid panels of each bin. The lamps are illuminated with LED that can be accessed for service from the inside of the bin. The LED can not be serviced and must be replaced as a lamp assembly. Refer to LAMP, RAM BOX, REMOVAL AND INSTALLATION .
• ON/OFF Switch  - The interior lighting of each bin can be manually controlled using a push-button ON/OFF toggle switch with a plunger sealed beneath a rubber button or boot located in the rear end panel of each bin.
• Wire Harness  - A wire harness concealed on the outside of each bin connects each of the lamps and switches to each other. A connector on the underside of the bin near the base of the rear end panel connects each bin wire harness to the vehicle electrical system through a take out and connector of the body wire harness.

The storage bin LEDs, and the rubber button (or boot) for the manual ON/OFF switch are each available for individual service replacement. The manual ON/OFF switch is serviced only as a unit with the storage bin wire harness. If the ON/OFF switch is damaged or ineffective, the entire storage bin wire harness must be replaced.

The components and circuits of the Ram Box storage bin lighting may be diagnosed using conventional diagnostic tools and procedures. Refer to the appropriate wiring information.