LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 1823 (Lamps/Lighting - Exterior (Service Information) - 2500HD & 3500HD) >> Lamp, Ram Box >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2019 RAM 3500 HD and 2019 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

REMOVAL 

NOTE:

Lid lamp is shown. Ram Box lamp is the similar.

GC0185853Courtesy of CHRYSLER GROUP, LLC
  1. Open the Ram Box lid.
  2. Disconnect and isolate the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECT .
  3. Release the retaining tab (4) and separate the light (3) from the lid (1).
  4. Disconnect the wire harness connector (2).

INSTALLATION 

  1. Connect the wire harness connector (2).
  2. Install the light (3) into the opening (1) on the Ram Box lid and seat fully.
  3. Connect the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECT .
scientia non olet · About LEMON Manuals