Instrument Panel: Bezel-Center: Installation
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- If removed, install the instrument panel air outlets onto the back of the center bezel (Refer to HEATING & AIR CONDITIONING/DISTRIBUTION/OUTLETS-AIR - INSTALLATION) .
- If removed, install the power window switches onto the back of the center bezel (Refer to ELECTRICAL/POWER WINDOWS/SWITCH-POWER WINDOW - INSTALLATION) .
- If removed, install the clock onto the back of the center bezel (Refer to ELECTRICAL/CLOCK - INSTALLATION) .
- If removed, install the A/C-heater control and the accessory switch bezel onto the back of the center bezel. Install and tighten the retaining screws to 2 N.m (17 in. lbs.).
- Position the center bezel (1) to the instrument panel (2) and connect the control cables and wire harness connectors to the back of the A/C-heater control (Refer to HEATING & AIR CONDITIONING/CONTROLS/CONTROL-A/C HEATER- INSTALLATION) .
- Connect the wire harness connectors to the accessory switches, clock and power window switches (as equipped).
- Install the center bezel onto the instrument panel. Make sure the snap retainers are fully engaged to the instrument panel.
- Reconnect the negative battery cable.