LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (HVAC Systems (Service Information)) >> Controls >> Cable-Temperature Control >> Installation

Cable-Temperature Control: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Cable-Temperature Control
GC0043295Courtesy of DAIMLERCHRYSLER CORP.
NOTE: Illustration shown with instrument panel removed for clarity.
  1. Position the temperature control cable (2) to the left side of the HVAC air distribution housing (3).
  2. Connect the temperature control cable to the blend door pivot lever (4).
  3. Install the screw (1) that secures the temperature control cable to the air distribution housing. Tighten the screw to 2 N.m (17 in. lbs.).
  4. Install the steering column opening cover, (Refer to BODY/INSTRUMENT PANEL/COVER-STEERING COLUMN OPENING - INSTALLATION) .
  5. Connect the temperature door control cable to the A/C-heater control and install the instrument panel center bezel (Refer to BODY/INSTRUMENT PANEL/BEZEL-CENTER - INSTALLATION) .
  6. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals