Section 23 (Body - Interior & Exterior): Interior: Carpet: Removal: Rear
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the driver and passenger front seats from the vehicle. (Refer to BODY/SEATS/SEAT-FRONT - REMOVAL) .
- Remove the center console from the front floor panel transmission tunnel. (Refer to BODY/INTERIOR/FLOOR CONSOLE - REMOVAL) .
- Remove the trim from the inside of both lower B-pillars. (Refer to BODY/INTERIOR/B-PILLAR TRIM - REMOVAL-LOWER) .
- Remove the rear seat cushion from the vehicle. (Refer to BODY/SEATS/REAR SEAT CUSHION COVER - REMOVAL) .
- Remove the scuff plate from both rear door sills. (Refer to BODY/INTERIOR/REAR DOOR SILL SCUFF PLATE - REMOVAL) .
- Remove the push-pin fasteners (2) that secure the outboard edges of the rear carpet (3) near the front of each rear door opening (1) sill.
- Lift the rear carpet from the floor panel far enough to extract the body wire harness take outs and connectors through the appropriate slits in the carpeting.
- Remove the rear carpet from the vehicle through one of the rear door openings.