Cushion/Cover-Cushion - Front: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cushion Nuts

Courtesy of DAIMLERCHRYSLER CORP.

Before proceeding with the following repair procedure, review all warnings and cautions. (Refer to BODY/SEATS - WARNING)
Move the seat to the forward position and disconnect and isolate the batter negative cable.
Remove the bolts (2) and the clamps (1) and remove the seat cushion.
Disconnect the electrical connector, if equipped.

Fig 2: Zip Strip
Courtesy of DAIMLERCHRYSLER CORP.
Separate the j-straps (1 & 2) and seat cushion cover and foam.