LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (6.1L Engine (Service Information)) >> Tappets-Hydraulic Roller >> Removal

Tappets-Hydraulic Roller: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative cable from the battery.
  2. Remove the air cleaner. Refer to REMOVAL .
  3. Remove intake manifold (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - REMOVAL) .
  4. Remove cylinder head cover. (Refer to ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - REMOVAL) .
  5. Remove rocker arm assembly and push rods. (Refer to ENGINE/CYLINDER HEAD/ROCKER ARM / ADJUSTER ASSY - REMOVAL) . Identify push rods to ensure installation in original location.
  6. Remove the cylinder head. Refer to REMOVAL .
    Fig 1: Remove/Install Hydraulic Roller Tappet
    GC0003965Courtesy of DAIMLERCHRYSLER CORP.
    1 - TAPPET RETAINER
    2 - HYDRAULIC ROLLER TAPPET
  7. Remove bolt from tappet guide holder.
  8. Remove tappet guide holder.
  9. Pull tappet out of bore with a twisting motion. If all tappets are to be removed and reused, identify tappets to ensure installation in original location. 
  10. Check camshaft lobes for abnormal wear.
scientia non olet · About LEMON Manuals