LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (6.1L Engine (Service Information)) >> Manifold - Intake >> Removal

Manifold - Intake: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine covers. See Figure.
  2. Bleed fuel system. Refer to FUEL SYSTEM .
  3. Disconnect negative cable from battery.
  4. Remove air inlet hose.
  5. Disconnect electrical connectors for the following components:
    1. Manifold Absolute Pressure (MAP) Sensor
    2. Fuel Injectors
    3. ETC ( Electric Throttle Control )
  6. Disconnect brake booster hose, purge hose, and MUA hose (Make Up Air Hose).
  7. Remove intake manifold retaining fasteners in a crisscross pattern starting from the outside bolts and ending at the middle bolts.
  8. Remove intake manifold as an assembly.
scientia non olet · About LEMON Manuals