In Vehicle
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- The valve stem seal/valve spring seat (4) should be pushed firmly and squarely over the valve guide using the valve stem as guide. Do Not Force seal against top of guide. When installing the valve retainer locks (1), compress the spring (3) only enough to install locks (1).
- Follow the same procedure on the remaining cylinders using the firing sequence 1-2-3-4-5-6. Make sure piston is at TDC on the cylinder that the valve spring is to be removed.
- Remove spark plug adapter tool and Special Tool MD 998772A.
- Install rocker arm(s) (Refer to ENGINE/CYLINDER HEAD/ROCKER ARMS - INSTALLATION) .
- Install camshafts (Refer to ENGINE/CYLINDER HEAD/CAMSHAFT(S) - INSTALLATION ), timing chain (Refer to ENGINE/VALVE TIMING/TIMING BELT/CHAIN AND SPROCKETS - INSTALLATION) , and timing chain cover (Refer to ENGINE/VALVE TIMING/TIMING BELT / CHAIN COVER(S) - INSTALLATION ).
- Install cylinder head covers (Refer to ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S) - INSTALLATION ).
- Install upper intake manifold (1) (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION) .
- Install air cleaner housing (3) and inlet hose (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - INSTALLATION) .
- Connect negative battery (1) cable.