LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Mechanical Brake System - Base (Service Information)) >> Pedal >> Removal >> Pedal - RHD

Pedal - RHD

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move driver's seat to full rearward position.
    Fig 1: Disconnecting/Connecting Battery Cables
    GC0012970Courtesy of DAIMLERCHRYSLER CORP.
  2. Disconnect and isolate battery negative cable (2) from battery post.
  3. Remove driver side silencer under instrument panel. (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL SILENCER - INSTALLATION)
  4. Remove steering column opening cover. (Refer to BODY/INSTRUMENT PANEL/STEERING COLUMN OPENING COVER - INSTALLATION)
    Fig 2: STOP LAMP SWITCH MOUNTING - RHD
    GC0039419Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove stop lamp switch (2). (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/BRAKE LAMP SWITCH - REMOVAL)
    Fig 3: View Of Pedal Retaining Clip
    GC0039420Courtesy of DAIMLERCHRYSLER CORP.
    CAUTION: When removing booster push rod from brake pedal pin, be careful not to damage rubber O-ring on pin.
  6. Remove booster push rod from pin on brake pedal. To do so:
    • Position small screwdriver (1) between center tang on power brake booster brake pedal pin retaining clip (4).
    • Rotate screwdriver enough to allow retaining clip center tang to pass over end of brake pedal pin (3), then slide retaining clip off brake pedal pin.
    • Discard retaining clip. It is not to be reused. Install NEW retaining clip when assembling. 
  7. Slide booster push rod (2) off brake pedal pin (3).
    Fig 4: RADIO AMPLIFIER /TRANSMISSION CONTROL MODULE
    GC0039417Courtesy of DAIMLERCHRYSLER CORP.
  8. Remove two lower (2) and one upper mounting screw fastening the radio amplifier/transmission control module assembly (1) in place.
  9. Disconnect four wiring connectors and remove radio amplifier/transmission control module assembly (1).
    Fig 5: BOOSTER AND PEDAL MOUNTING - RHD
    GC0039418Courtesy of DAIMLERCHRYSLER CORP.
  10. Remove four power brake booster (2) mounting nuts (5).
  11. Remove two nuts (4) fastening pedal bracket to upper dash panel (3).
  12. Push power brake booster (3) forward into engine compartment as far as possible by hand. Do not force it.
  13. Remove brake pedal (1).
scientia non olet · About LEMON Manuals