LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Body - Interior & Exterior) >> Instrument Panel >> Cover-Steering Column Opening >> Installation

Cover-Steering Column Opening: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Reinforcement I/P Steering Column
GC0013216Courtesy of DAIMLERCHRYSLER CORP.
  1. If removed, position the instrument panel steering column cover reinforcement (1) onto the bracket (2).
  2. Install the screws (3) that secure the instrument panel steering column cover reinforcement to the bracket. Tighten the screws securely.
    Fig 2: Steering Column Cover, Wiring Connector & Park Brake Release Cable
    GC0013217Courtesy of DAIMLERCHRYSLER CORP.
  3. Position the steering column cover (1) into the vehicle.
  4. Connect the release cable (4) to the emergency brake release handle (5).
  5. Connect the wire harness connector (3) to the trunk release switch, if equipped.
  6. Install the steering column cover onto the instrument panel and carefully push on the top and right side of the cover to fully seat the snap clip retainers into the instrument panel.
  7. Install the screws (2 and 6) that secure the steering column cover (1) to the instrument panel. Tighten the screws securely.
scientia non olet · About LEMON Manuals