LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Lighting Systems - Exterior (Service Information)) >> Switch - Stop Lamp >> Removal

Switch - Stop Lamp: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Stop Lamp Switch and Pedal Rod
GC0014396Courtesy of DAIMLERCHRYSLER CORP.
  1. Depress and hold the brake pedal.
  2. Remove the stop lamp switch (2) from it's bracket on the brake pedal assembly (6). To do so, rotate the stop lamp switch in a counterclockwise direction approximately 30 degrees from its proper mounting position. Pull the switch rearward and remove it from its mounting bracket.
  3. Disconnect the wiring harness connector (1) from the switch.
scientia non olet · About LEMON Manuals