LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Manual HVAC Systems - Except Coupe >> Diagnostic Tests >> Test W: RECIRC Door Output Shorted To Ground >> Test Procedure

Test Procedure

  1. Start engine. Using scan tool, erase BCM DTCs. Turn blower switch to low setting. Place temperature control switch to full heat for 30 seconds, then full cold for 30 seconds, then back to full heat for 30 seconds. Place mode selector switch in each position, pausing for 20 seconds in each detent position. Place mode selector switch in defogger position for 20 seconds, then recirculation position for 20 seconds, then back to defogger position for 20 seconds. Using scan tool, read BCM DTCs. If scan tool displays RECIRC DOOR OUTPUT SHORTED TO GROUND, go to next step. If RECIRC DOOR OUTPUT SHORTED TO GROUND does not appear in scan tool display, go to step  3.
  2. Turn ignition switch to OFF position. Disconnect BCM C2 connector. Close all doors and ensure all lights and courtesy lighting is off. Using DVOM, measure resistance between ground and BCM C2 connector terminal No. 24 (Gray/Dark Blue wire). See Figure. If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, repair short to ground in Gary/Dark Blue wire. See WIRING DIAGRAMS . After repair, go to step  4.
  3. Turn ignition switch to OFF position. Visually inspect related wiring harnesses, connectors and components. Check for damaged or chafed wiring, damaged or broken connectors and/or components. Check for Technical Service Bulletins (TSBs) from manufacturer that may apply. Repair any faulty condition found as necessary. After repair, go to next step. If no faults are found, test is complete.
  4. After repair is complete, perform calibration test. See CALIBRATION TEST - HVAC DOOR MOTORS  under ADJUSTMENTS. Perform verification test. See BODY VERIFICATION TEST VER-1  under VERIFICATION TESTS.